Видео

I changed out the blower motor...it's still not turning. I think I may need to get a new resistor or connector 👀🤔thanks for this video! Keeps me from having to outsource!❤❤

LMAOOOO

Did my 2017 CRV with a friend pumping the brakes and it took 30 onces of fluid to do it

Just encountered this today on my 2014 @ 301K miles. I'm still hoping it's just a A/C Clutch Relay (fingers crossed). 🙂

spin the sensor around , turn it , its probly upside down inside the bottle

I bought a spark plug Fowler from AutoZone but I had to drill the inside of it to fit the tip of the oxygen sensor for my 2007 2.4 Honda Accord. It was a 350,000 miles vehicle and it was not worth to change the catalytic converter. A year later it got totaled and the junkyard paid me more because it had the original factory catalytic converter.

I’m so greatful for this video ❤❤❤❤❤❤❤

Your 2004 Sienna still not boiling water after you put new fan

Bro my only concern was the goddamn upper water neck going to the head... does that need to come off?

I like this video , I have a 2004 Toyota Sienna Nalley Toyota attempted to repair it my van still misfiring, service Rep / mechanic appears to not have knowledge as to what wrong with it this information is a great help to me

Really nice video! Well done

The hood cable is too long why

I watched this to see how to get my oil filter off and of course it doesn't show you taking it off only putting the new one on. Man why would they put it there? Crazy

Great video! Fixing to go diagnose my washer now

If the wear indicator is in the wrong side will that make a difference?

Whenever possible, use silicone grease instead of common bearing grease for odd boots like this antenna - the rubber lasts longer.

Thank you for your help sir ! ❤

Oil changes on these trucks are reason enough never to buy another one. What a bad design. Spin on oil filters been working for 60 years so lets make it harder and add the potential for 2 or 3 more places for an oil leak. Oh AND lets make the filter housing out of plastic as well. fck me..

Great video. Your breaks are the same I have so you gave me the map to get my fixed. Thanks.

What about the glove box arm on the side , don`t you have to slide that off ?

thanks this was easier than i thought, after putting it off for 6 days. i didn't have an actuator arm, the pieces popped off cleanly in about 2 minutes. hardest past was the bulbs not coming out easily so i had to come back here and then use gloves and put some oomph into pushing them out counterclockwise with both hands. afterwards it was easy. i couldn't get one of the trim pieces by the arm to look perfectly flush anymore even though it's clipped and tucked in, but i guess nobody is going to look up there. probably a 15 min job with instructions

Good video

Well, thanks for the video, looks like I know what I’m doing next weekend now

Thanks so much for this video! It addressed the exact problem with my Tundra, and helped me get in and fix it right. I also appreciate the part and tool suggestions because they were just what I needed too.

I might have rounded the long bolt for the engine mount bracket. Can I still remove the top cover with it still there? Will I be able to remove it in one piece?

@ 03:12 made me have to pee. No lie. Good video though thanks. Same leak for me on my LG Thinq.

um it's not the flip open door?

Hi I have a question? when replacing the catalytic converter, Is the original isolation aluminum plate installed inside? Is it necessary to install it? Thanks

You are the windshield wiper whisperer. 😂

Hello, you didn’t show how to get the two black connectors off that have the two wires? Do you just cut the wires or does the black harness connector pull off?

Thanks for taking the time to show this video. I would recommend checking your AC system for leaks, replacing the rubber oil lines, show the installation of the alternator, and be prepared to do this again in one year...Duralast....don't last....You'll be paying more for parts than you need to. Good luck!

I don't know what color my coolant is because I just got this car but I normally only see red coolant for semi trucks. Any reason why it's red in this car? Used to it being green.

I subscribed. Thank you

I need an engine replacement… what would y’all suggest? Going to a dealership or having it rebuilt? And if having it rebuilt, how would I go about finding someone to do it? Thanks in advance for any and all suggestions. I too have a 2013 Dodge Ram 1500 hemi

Glad you made this. I'm about to do mine in my gravel driveway. I'm not looking forward to this, but you made it look simple enough. Should be easy to do

I just finished replacing the 6 spark plugs This video is very honest to tell the viewers that the biggest challenge is the removal of the 3 bolts( one 14 and two 12) behind the air intake. I had to lie on the engine(with a thick cardboard underneath ) to gain access to the 3bolts. After the replacement I do not bother to put them back( except the throttle one). I think the air intake is already sturdy enough with the 4 or 5 Allen screws Good luck

It's happening on my 2008 Lincoln town car with 235,556 miles.

I use a form a funnel or similar device to keep the oil filter runoff off the driver side rack bushing

The master cylinder has a bleeder port. Put a hose on that and put the other end in the reservoir. Pump pump pump. Get the air out. Bleed the left front tire first. Then Right rear Left rear Right front Left front Done

I've got the same issue, but nope I'm not doing all of that.

Thank you!!!

Thank you for this video. It really was a big help at getting the top and back off my washing machine. I was very intimidated by all the wires and movement of the drum after removing them. So, much so, I waited for my son to arrive to assist me. Luckily he found the issue rather quickly. Mine was a black tube at the top back left side of the machine. It had worked it's way loose and water was gushing out of it whenever I turned the machine on. It took us several times to figure it out though. Man, I'm so thankful it wasn't an expensive fix.

How many miles on the ram,what oil do you use

U could of just replaced the puddle lights

Great video,which truck do you like the best

I have a 2015 Sequioa. Also keep in mind that there is a filter inside the passenger dash that needs replacing that will cause the AC to work inconsistently. Napa part 4511

Unfortunately I just had the same symptoms. Worse cost. 2017 Tundra with just 69K miles. Driving and AC stops blowing cold. I did some online searching and diagnosing as you did. Was not just a relay as everyone else says. Took to dealership they replaced the clutch and compressor and dryer box for $2K, still didn’t work. At that point Toyota says they need to pull apart entire dash to also replace evaporator and expansion valve box. Another $2.5K. !!!! This truck is still a baby in my eyes with 69K miles and a $4.5K repair. I was planning to buy a nice LEER extra tall canopy shell this year- instead I rebought my entire AC system. 🤦‍♂️

I replaced mine and 2 sensors still getting the same code.

Great video! Very informative. I have a similar issue, but not blowing the fuse. When I hot wire the clutch it does engage. I'm thinking the problem is the wire between the relay and the clutch somewhere. Would you agree?

Hmmm. Why didn’t you take off the top manifold? Just wondering. Nice vid nonetheless